top of page
SLAB GUARD CONCENTRATE
YB4 GUARD is a proprietary water-based polymer stain Guard which bonds to any concrete slab or cementitious topping. YB4 GUARD protects slabs from oils, food based acids and other contaminants that can damage concrete. YB4 GUARD protection also allows for extended clean-up times, increased shine and enhances colored concrete. YB4 GUARD application is recommended as a final step in polishing concrete floors.
PROPRIETARY WATER BASED POLYMER FORMULA
PUMP SPRAYER APPLICATION
5, 55 & 275 GALLONS
CUSTOM FILLS & PAIL COLOR
DOWNPACK & DILUTE ONSITE AND INCREASE PROFITS 50-80%
MIXING AND APPLICATION
CONCRETE POLISHING MATERIAL
YB4 GUARD will cover 1,000 square feet per mixed gallon
Mix Ratio for YB4 GUARD is 4 gallons of clean potable water to 1 gallon YB4 material.
EQUIPMENT Apply YB4 GUARD using a Pump Sprayer
STEP: 1 Mix (1) part YB4 GUARD with (4) parts water into a pump sprayer. Traveling across the slab in an east to west direction, apply YB4 GUARD solution generously without puddling at a coverage rate of 1,000 square feet per gallon. NOTE: Tuff-Track Process mix ratio is 2 parts water and 1 part YB4 GUARD.
STEP: 2 Work the YB4 GUARD across the sprayed area with an YB4 GUARD dampened microfiber pad, moving the pad in a north/south motion first before using a figure 8 pattern to spread the YB4 GUARD solution evenly. Allow 2 to 4 hours dry time before final burnishing.
STEP 3: Use a high speed burnisher mounted with a burnishing heat or hogs hair pad in a north/south, east/west pattern. Dry mop floor and, following the same process, apply a second coat of ISG. Burnish after drying within 4 hours.
SUPERIOR RESISTANCE TO FOOD ACIDS AND OILS
APPEARANCE: Opaque White ODOR: None
SPECIFIC GRAVITY: 1.15 - 1.19 @ 77 °F / 25 °C DENSITY: 9.6 – 11.0 lb/gal SOLUBILITY IN WATER: Complete pH (100 %) 8.0 - 9.5
VISCOSITY: 15 cps @ 77 °F / 25 °C
FREEZING POINT: 32 °F / 0 °C
VOC CONTENT: 0.00 % EPA Method 24
VIEW TEST RESULTS
bottom of page