top of page
YB_blank.png

{

YB.png

4

SLAB DENSIFIER CONCENTRATE

YB4 DENSIFIER  fortifies concrete slabs with a concentrated proprietary formula that penetrates to increase surface density and hardness. YB4 DENSIFIER can be applied at the time of placement as well as to older fully cured slabs to eliminate dusting and reduce porosity. YB4 DENSIFIER is especially effective to protect concrete floors subjected to steel wheel and forklift traffic.

MIX RATIO 
3:1 

 LOW pH AMORPHOUS COLLODIAL SILICA FORMULA 

AUTO-SCRUBBER OR PUMP SPRAYER APPLICATION 

STANDARD PACKAGING 

5, 55 & 275 GALLONS  

CUSTOM FILLS  & PAIL COLOR
OPTIONS AVAILABLE

DOWNPACK & DILUTE ONSITE AND INCREASE PROFITS 50-80% 

COVERAGE 

MIXING AND APPLICATION 

CONCRETE POLISHING MATERIAL

AUTO SCRUBBER APPLICATION METHOD: YB4 DENSIFER is a proprietary formula designed to be applied to high & medium density concrete as well as high porosity and hard concrete.

Application rate: 375 square feet per gallon with auto scrubber set at full flow. - 15 Gallon tank fill will cut 5,675 square feet of concrete slab - 30 gallon tank fill will cut 11,350 square feet of concrete slab

PUMP SPRAYER APPLICATION METHOD:  375 - 400 square feet per gallon.

Dilution: Mix Ratio for both auto scrubber and pump sprayer application: 3:1

1. Open package concentrate
2. Mix 3 parts clean potable water to 1 part YB4 DENSIFIER
3. Mix can either be within the auto scrubber or pump sprayer 15 gallon auto scrubber tank - 3.75 Gallons. YB4 DENSIFIER 30 gallon auto scrubber tank - 7.5 Gallons YB4 DENSIFIER Pump Sprayer ratios depend on pump sprayer size Note: To facilitate mixing and agitation, place YB4 DENSIFIER into the mixing vessel first and then fill with clean potable water.

EQUIPMENT:  Apply YB4 DENSIFIER using a mechanical auto scrubber or pump sprayer. For pump sprayer application, use either a fan tip or cone tip to ensure even spraying

INCLUDES FREEZE GUARD TECHNOLOGY

CANNOT BE OVERAPPLIED AND WILL NOT LEAVE MINERAL SALT DISCOLORATION 

PHYSICAL PROPERTIES 

 PHYSICAL STATE Liquid APPEARANCE Opaque White ODOR None
SPECIFIC GRAVITY 1.15 - 1.19 @ 77 °F / 25 °C
DENSITY 9.6 – 11.0 lb/gal
SOLUBILITY IN WATER Complete pH (100 %) 2.6 - 3.2
VISCOSITY 15 cps @ 77 °F / 25 °C
FREEZING POINT 32 °F / 0 °C
VOC CONTENT 0.00 % EPA Method 24

Note: These physical properties are typical values for this product and are subject to change

bottom of page